I have been working off and on with a complex project, trying to get my PBX in a Flash 2.9 to work with my CUCM 8.5 and connect to google voice. Simply put:
GOOGLE VOICE------>PIAF<----SIP TRUNK---->CUCM<----IP PHONES
I have achieved outgoing calls from the IP phones but the incoming calls still fail.
Logs show call from GV Trunk inbound then sent to the SIP trunk, the destination digits are "tdial" and it is listed as answered. On the phone you hear "Google Voice Subscriber you are calling is not available."
The config I am currently tinkering with is to have a DN on the CUCM (1999) that is going to terminate all incoming calls. This is the config on the PIAF:
Matches Routes = GV
EXACT GV PHONE NUMBER
Matches Routes = CUCM
Ring Groups To CUCM 1999
I have also configured the SIP Trunk to be included in the Generated_CSS_I_E Calling Search Space (where all my phones are attached). I have messed with incoming digits being striped and I am out of luck.
Anyone done this before or even have an easier solution for this?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...