They are saying the problem is due to the 2 "Term_Dial_Tone" that we, the originator, are sending them.
They tested on the same channel, going in the same direction, but calling from the front side of the router, basically in front of the router so that the router is not in the picture. The router is a 3825
This is the controller config
controller T1 0/1/0 cablelength long 0db ds0-group 0 timeslots 1-18 type e&m-wink-start dtmf dnis ds0-group 1 timeslots 21-24 type e&m-wink-start dtmf dnis
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.