Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ata 186 14400

Anyone able to get an ATA to run at 14400?

thx as always

2 REPLIES
Super Bronze

Re: ata 186 14400

Hi

General tips:

1) Disable ECM and any high-speed/fancy features you can on the fax front panel itself

2) Ensure your E1s have no clock slips using 'sh controllers e1'

3) Ensure you have a 100% QoS setup with as little packet loss as possible

4) Be happy if your faxes work.. the above tend to improve reliability but slower speeds are typical on ATAs in my experience.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Cisco Employee

Re: ata 186 14400

Can you explain your topology in more detail?  What protocol are you running on the ATA?  What VoIP protocol is your PSTN gateway running?  And What is the PSTN connection?  Is the PSTN connection an IP SIP trunk?

157
Views
0
Helpful
2
Replies
CreatePlease login to create content