cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
335
Views
0
Helpful
2
Replies

ATA 186, 188

wweinberger
Level 1
Level 1

I have 3 ATAs that will not even connect to the network.  They came from other locations and I do not know how to get into them to change IP address, etc.  The red light is flashing but I am not getting any link lights.

2 Replies 2

James Hawkins
Level 8
Level 8

If you do not know what settings are on the ATA's your best bet is probably to use the built in IVRto change/test the IP settings.

Follow the procedures at the link below.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800c3a50.shtml#task3

wweinberger
Level 1
Level 1

I tried that but I don't get dial tone.  All I can hear is clicking.

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: