I am using CCM 4.1. Today, I connected ATA186 and able to see the below macs in callmanager.
Phone 1 Mac: ATA0022900409F5
Phone 2 Mac: ATA22900409F501
Phone 1 - Configured 2854 as DN (It is working fine internally and externally)
Phone 2 - Confgiured 2856 as DN (Internal calls are fine. But, when I try to reach from PSTN to full number xxxxxx2856, remote party is able to hear the ring tone and when he picks up the phone it is going to engage tone)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...