ATA 186 - Two ports configured. 1st port, no issues whatsoever. But calls to the 2nd Port immediately disconnects upon answering. So far, checked device pool and that looks ok. Checked region settings on CCM4.1 codec, set to G.611.
Re: ATA 186 - 2nd Port drops calls upon answering.
What you are probably seeing is a limitation of the ATA. It supports g.711 on both ports but only g.729 on 1 port, port 1 by default. To test this hypothesis you can move the g.729 function to port 2 and see if the problem starts occurring on calls to the port 1. phone. Change the connect mode to 0x90200400 and apply to the ATA and then try the calls to the both phones. If this is confirmed you will have to have the 2nd port in a region that uses g.711 for all calls (after you revert back to the original connect mode).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...