Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA 186 Factory reset protection

How to configure OpFlags bits 28-31 with a value of 6 via IVR?

3 REPLIES
New Member

Re: ATA 186 Factory reset protection

Disconnect the ethernet cable. Plug phone to phone1 jack.

Step 1 Lift the handset and press the Function button located on top of the Cisco ATA 186.

Step 2 Enter the IVR menu number for the parameter that you want to configure or the

command that you want to execute; then, press the pound key(#).

IStep 3 Follow the applicable prompts.

Step 4 When you have finished, make sure you press 3 to save your changes.

Step 5 Hang up the telephone. The Cisco ATA 186 resets.he function button will fast-blink when the

reset is complete.

reboot (sometimes required)

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/atarn/atarn16.htm#89135

New Member

Re: ATA 186 Factory reset protection

Hello,

Thank you but the question is not how to use the IVR.

The question is HOW TO CONFIGURE OpFlags BITS 28-31 WITH A VALUE OF 6 VIA IVR?

New Member

Re: ATA 186 Factory reset protection

check the ATA admin guide.

i did not do it personally but it is the voice menu "323"

632
Views
0
Helpful
3
Replies