ATA 186 on CME

[lukeprimm]

I have to add an analog phone to one of our remotes sites and I want to use an ATA 186 that we already own.  Do the ATA 186 use a load file like a phone does?  Ive seen some simple documentation that states you set it up like a phone?  Thanks

[paolo bevilacqua]

Yes, you should have SCCP firmware on the ATA.

It will then basically behave like an IP phone.

The documentation is the normal CME and ATA one.

[lukeprimm]

thanks, do I have to make sure a certain "load file" is in flash and available? If so, what file?  We have plenty of 7960 and 7961 that work fine already.  thanks

[acampbell]

Hi,

Look at this link

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebasic.html#wp1224718

HTH

Alex