I have CCME 4.1 I need to install an ATA and connect a fax into the first port. I have read the ATA admin guide, and find it rather confusing. I have managed to get as far as getting an ip address on the ATA, but it wont register. I have set up the mac address on the ephone and have created an ephone-dn.
Does anyone have a typical config that they have found successful? the settings on the ATA and the config on the gateway?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...