Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA 186

Dear All,

I have 2 ATA 186, at present they are communicating on Port 1. If I want to have communication on Port 1 and Port 2 simultaneously, is there a way that both port runs on G729 simultaneously.

Rgds,

Jitesh

3 REPLIES
New Member

Re: ATA 186

Jitesh,

The ATA will either allow G.729 on Phone one _OR_ Phone two. This setting is governed by Bit 21 of ConnectMode.

See the paste below from the following URL:

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00800c4d1f.html#42433

~~~BEGIN PASTE~~~

ConnectMode

Description

This parameter is a 32-bit bitmap to control the connection mode of the selected call signalling protocol. Table 5-2 provides bit definitions for this parameter.

Default

0x90000400

21

0?Enable G729 on the Phone 1 FXS port.

1?Enable G729 on the Phone 2 FXS port.

~~~END PASTE~~~

Bit 21 is 0 by default.

To enable G729 on Phone 2 instead use 0x90100400 here.

In my testing I was able to register both ports in a DP which specified a G711 region. I was able to call successfully to other phones then.

When Phone 2 is set in a 729 DP & Region, I am unable to call out. Reorder is provided after another DN is dialled.

Even setting the above ConnectMode value, returning Phone 1 to 711, Phone 2 as 729, I am still unable to dial other DNs. 711 on Phone 2 works fine.

Please rate helpful posts.

Thanks.

New Member

Re: ATA 186

Dear jgolia ,

Thanks for reply,but I have tried all the guidence provided by u before posting query.

Rgds,

Jitesh

New Member

Re: ATA 186

>>Bit 21 is 0 by default.

>>To enable G729 on Phone 2 instead use >>0x90100400 here.

I think this should be:

0x90200400

138
Views
0
Helpful
3
Replies
CreatePlease to create content