ATA-187 9.2.31 Firmware SSH and second line, terminal flood
I recently updated my ATA-187 units to 9.2.31 to see if it would eliminate some stability issues with devices becoming deregistered and having to be manually power-cycled (without POE this lack of control is frustrating).
I enabled the new SSH login feature and logged into my units to see what was available. the interface is almost impossible to use because I don't have autoreg turned on and my second lines are not configured in CUCM. The console is constantly flooded with TFTP download attempts for the second line MAC. I could find no way to stop this terminal monitor type behavior and no way to make it at least synchronous.
Also, most dissappointing is the lack of a command (at least via contextual help) to reload the unit.
So my questions are:
Does anyone know a way to silence the second line registration attempts, either by preventing the ATA from trying or by quieting that terminal output.
Does anyone know any command or other method by which to reload or power-cycle the ATA remotely if the unit is not registered?
Does anyone know other undocumented commands that address the above or would be useful for other reasons?
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...