Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATA-187 firmware 9.2.3 and plus e.164 dialing

I've read the release notes for the new firmware for the ATA-187 (9.2.3) which supports plus dialing by using the '*' (star) key. However I've tried installing this firmware to test the feature, but the star key doesn't seem to be past to CUCM.

I installed both the QED file and the firmware as detailed in the release notes.

Is the feature only supported in CUCM 8.6??

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/187/9_2_3/english/release/notes/atarn923.html#wp32015

Sent from Cisco Technical Support iPad App

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ATA-187 firmware 9.2.3 and plus e.164 dialing

looks like you need to open a TAC case!!

thanks,

Vipul Jindal

6 REPLIES
Cisco Employee

ATA-187 firmware 9.2.3 and plus e.164 dialing

as the document states

Use these release notes with a Cisco ATA 187  Analog Telephone Adaptor running Firmware Release 9.2(3) (SIP). This  version of Firmware Release 9.2(3) is compatible with Cisco Unified  Communications Manager 6.1(5) and later.

whats your call manager verison?

thanks,

Vipul Jindal

New Member

ATA-187 firmware 9.2.3 and plus e.164 dialing

The verison of CUCM is 8.5.1-10000-17

Cisco Employee

ATA-187 firmware 9.2.3 and plus e.164 dialing

did u check if ATA has taken the new firmware??

also how you are testing it?

thanks,

Vipul Jindal

New Member

Re: ATA-187 firmware 9.2.3 and plus e.164 dialing

I verified the new firmware was installed on the ATA under the ATA's web ui.

In CUCM I've created translation patterns that take the +e.164 and route the calls to the local extensions, I've also changed a single extension to +e.164 number these numbers I can dial using CUPC +e.164 numbering.

When I attempt to dial the number on the ATA using * I receive fast busy.

DNA confirms that the patterns should be matched from the ATA

Cisco Employee

Re: ATA-187 firmware 9.2.3 and plus e.164 dialing

looks like you need to open a TAC case!!

thanks,

Vipul Jindal

Re: ATA-187 firmware 9.2.3 and plus e.164 dialing

Did you hold down * for 2-3 seconds? I know on other models the * is used to but you need to hold * for a second for it to change to +

Sent from Cisco Technical Support iPhone App

552
Views
0
Helpful
6
Replies
This widget could not be displayed.