Before using the 9.2(3) firmware for Cisco ATA 187 with Cisco Unified Communication Manager Release 6.1.5, 8.6 and higher, you must install the QED on the Cisco Unified Communication Manager publisher in the cluster.
and thanks for your respond. I have installed QED and restart tftp and callmanager. But the ATA187 is unimpressed. He become IP-Adress, Mask, GW and TFTP-Server-Adresses, but does not connect with the Callmanager. The ATA is there unknown.
Over the WEB-Interface Device Log Status Messages writes continously:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...