12-27-2011 06:12 PM - edited 03-16-2019 08:43 AM
Dear all,
I check cisco document and found that, Cisco CME 9.0 support ATA 187 to connect fax/phone
I try to config SIP as bellow :
voice register global
mode cme
source-address 10.17.30.14 port 5060
max-dn 20
max-pool 20
tftp-path flash:
create profile sync 0086112851333914
!
voice register dn 1
number 8556
!
voice register dn 2
number 8557
!
voice register pool 1
id mac 0C85.25A6.9845
type ATA-187
number 1 dn 1
codec g711ulaw
!
voice register pool 2
id mac 8525.A698.4501
type ATA-187
number 1 dn 2
codec g711ulaw
!
But the ATA 187 cannot register with CME 9.0
i did debug command "debug tftp events" and found the error as below:
Dec 28 02:09:48.153: TFTP: Looking for CTLSEP0C8525A69845.tlv
Dec 28 02:09:48.389: TFTP: Looking for ATA0C8525A69845.cnf.xml
Dec 28 02:09:48.389: TFTP: Opened system:/its/vrf1/ATADefault.cnf.xml, fd 4, size 403 for process 153
Dec 28 02:09:48.393: TFTP: Finished system:/its/vrf1/ATADefault.cnf.xml, time 00:00:00 for process 153
Dec 28 02:09:48.905: TFTP: Looking for CTLSEP8525A6984501.tlv
Dec 28 02:09:49.125: TFTP: Looking for ATA8525A6984501.cnf.xml
Anyone who can help me with this issue
Thanks,
Minh
12-29-2011 06:14 PM
Problem has been fixed
01-06-2012 03:00 PM
What did you do to address this? I'm having a similar problem although i'm trying to SCCP register the ata
01-08-2012 09:56 AM
ATA 187 is supported with CME 9.0 only as SIP Endpoint not SCCP. Pls refer http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucme/requirements/guide/cme90spc.html
Pls rate the post if it helps.
GP.
05-21-2012 12:49 PM
Care to elaborate on how you fixed the problem. As of right now Cisco's documentation state 9.22 works. However there isn't a 9.22 firmware file available for download. There is a 9.23.1, but it appears to be for communications manager. Any help would be much appreciated regarding firmware files download link, tftp-sever commands, and telephony-service loads command used to fix the problem.
05-21-2012 11:07 PM
For ATA, phones, etc. fimware is the same for CM or CME.
So 9.23 is newer than 9.22 and that is what one would try first.
04-27-2012 09:52 AM
Hi huanng.isp
What is version of ATA 187 ? In the documentation is showing that we need the version 9.2.2 but I can't find the firmware on the cisco's site.
What are your IOS version of the router to support the cucme 9.0 ?
Regards,
Vinicius S Ramos
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: