Currently as it seems CUCM only allows you to configure at most a Maximum Number of Calls of 2 under the line configuration for an ATA-187. Is there any way to increase this number greated than 2?
You run into a problem if you want to configure the line for a fxs port on the ATA-187 to be a shared line. If it's a shared line with two phones (e.g. FXS port 1 and port 2 on the ATA) you lose call waiting and the ability to handle more than one call on a phone since you would want to configured the busy trigger as 1 for both. If it's a shared line with three phones (e.g. FXS port 1 and 2 and an IP phone) you can run into the situation that a port on the ATA would be unusable if the other port on the ATA is active along with the other shared line on the IP Phone is active.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...