Re: ATA - FAX not send when using Super G3 Faxes!!
Did you ever figure tis out? I have the same issue. Except I have several G3 fax machines working, the only issue I have with one of them is when sending to a digital fax number, one that is tied to an e-mail address rather than a fax machine. I am using the Kyocera Mita KM-F1050. These are G3 faxes and work fine except for one of like 7 fax machines. The only time it fails is when sending to a fax number tied to a fax software we use Xmedius.
Please let me know if you were able to resolve your issue without swapping fax machines.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.