Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ATA H323 and CME send fax but receive

Hi, I'm Fernando from Spain so I have configured settings for Europe.

I have a problem when receiving faxes.Sending fax is ok.

I've configured fax as FAX MODE, The parameters in ATA are:

audio mode:0x00120012

connect mode: 0x90002400

In CME i have in dial-peer the following :

dial-peer voice 9376 voip

description *** Outgoing Fax Calls ***

huntstop

destination-pattern 9977

no modem passthrough

session target ipv4:192.168.0.24

incoming called-number 914399977

fax-relay sg3-to-g3

fax rate disable

no vad

Thank you

Fernando

4 REPLIES
Hall of Fame Super Gold

Re: ATA H323 and CME send fax but receive

Hi,

does the FAX answer when you call 9977 ?

Is the call coming from ISDN and how are handling DID ?

Community Member

Re: ATA H323 and CME send fax but receive

Sorry, I wrote wrong the settings. Here is the settings corrected(DID isn't working):

dial-peer voice 9977 voip

description *** Outgoing Fax Calls ***

huntstop

destination-pattern 914399977

no modem passthrough

session target ipv4:192.168.0.24

incoming called-number 914399977

fax-relay sg3-to-g3

fax rate disable

no vad

When I call to 9977 is busy. When I call from outside to fax number 914399977 is ringing in my mobile phone but never pick up.

We use ISDN

Thank you

Fernando

Hall of Fame Super Gold

Re: ATA H323 and CME send fax but receive

Hi,

You may have issues with DID, do you have DID ?

Are the other CME extensions working OK ?

Can you send output of "term mon" and "debug isdn q931"?

Community Member

Re: ATA H323 and CME send fax but receive

Hi, I will answer myself. I have got to send fax. The problem was that the Telefonica line was failed.

Thank you very much

Fernando

166
Views
0
Helpful
4
Replies
CreatePlease to create content