Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATA Question

Hello,

Any help would be much appreciated.

Does anyone know how to configure an ATA to dial a number upon pick up ?

The ATA is interfaced with a Viking 1000-B board that is hooked up to a security gate intercom. Upon pushing the intercom button, I have managed to get a dial tone, bt need this to instead go to a specific extension.

3 REPLIES
New Member

Re: ATA Question

You'll need to investigate how to set up PLAR (Private Line Automatic Ringdown) on your call manager - CCM, CME, or Gateway.

Reference solution K87147415 in ciscowiki for a CCM example and a good explanation on the principles involved.

http://supportwiki.cisco.com/ViewWiki/index.php/How_to_configure_a_cisco_IP_phone_for_PLAR_in_Cisco_CallManager

New Member

Re: ATA Question

Thanks alot.

I set up a new PLAR. It works great.

Thank you very much !!!

New Member

ATA Question

Hello, I am in the same situation as you. But a little less farther.  I have a Viking 1000B and W3000 system.  When I connect an analog phone line on the pin 4 and 5 of the Viking 1000B the phone rings.  But when I connect it to an ATA, the line 1 is automatically lit up as green as soon as I connect the phone line from the analog phone to the Cisco ATA 187.  Can you give assistance on you configured it before the PLAR?  Thanks

194
Views
0
Helpful
3
Replies