Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA

I have just upgraded cm from v4 to 7 and some of the ata will not register with the publisher only the subscriber. phones seem ok and other ATA just a handfull will only register with sub not pub, anyway to factory reset them?

2 REPLIES

Re: ATA

You can reset the ATA to factory defaults using the procedure in the document below.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800c3a50.shtml

You will need an analogue phone with an RJ11 port to plug into the ATA to complete the procedure.

New Member

Re: ATA

Have you upgraded the firmware of your ATA?

163
Views
0
Helpful
2
Replies