Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA186 CM 6.1(3) Multicast MOH problem

I have an ATA 186 (firmware sccp 3.2.4) with CCM 6.1.3.1000-16, the moh is configured as multicast, the CCM and the ATA are in the same vlan, the multicast moh server is the CCM.

when the attached analog phone is placed on hold for the first time from an IP phone it can hear the moh... but when the analog phone is placed hold off it continues to hear the moh, and the only way for stopping the moh is to reset the ATA (!)...

The multicast moh between IP Phones instead works well...

Any solution to this singular behaviour for the ATA?

Many thanks

Roberto

339
Views
0
Helpful
0
Replies