Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ata186 fax issue ccm 4.1.3

Hi,

design is simple: mgcy gateway which has PRI line, ccm 4.1.3 and ata186

everthing is ok except sending fax. i am tyring to send fax to pstn but most of the time i got fail.

which settings should be for ata audio mode: 0015 , 0012, 0035 ?

which settings should be for ata connect mode:

which settings shoul be in mgcp gateway 2851 router : mgcp fax t38 inhibit, no modem passthrough,

there are lots of command but actually i did not understand clearly fax issue..

thkns a lot

4 REPLIES
New Member

Re: ata186 fax issue ccm 4.1.3

I do know that you can only run Fax and Modems on the first port. This is the only port that will do G.711

New Member

Re: ata186 fax issue ccm 4.1.3

Hi, me myself got it working with AudioMode 0x0015XXXX for port 2 or 0xXXXX0015 for port 1 and ConnectMode 0x90000400.

Best Regards

Daniel Larsson

New Member

Re: ata186 fax issue ccm 4.1.3

Where in gods name do you put these options??? I heard you can use a handset to program the ATA. but not anything this detailed

New Member

Re: ata186 fax issue ccm 4.1.3

You first have to go to the following URL: http:///dev. = ATA IP address.

From there you can configure your parameters.

282
Views
0
Helpful
4
Replies
CreatePlease to create content