Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Attendant consoel line status

Hi,

i've found a lot of posts about line status of phones from directory not showing in attendant console and have followed the instructions on how to fix it.

-There is no firewall

-The DNs have been added manually into speed dials

-The service on Call Manager is running

What else could be the problem? Is there any other solution?

Regards,

Marko

5 REPLIES
Cisco Employee

Re: Attendant consoel line status

try restarting RIS, are the DNs in the AC the same as the ones configured under CUCM??

i mean if the DN of a phone is 5558 is that the same in AC? or maybe you have a site code and it shows as 65558?

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Attendant consoel line status

I tried restarting. And yes, the DNs of phones are in same format as in CUCM.

Regards,

Marko

Green

Re: Attendant consoel line status

RIS service is not related to line status,

TCD is the service that takes care of that,

Attendant Console service in SeaDragon and up

Make sure Telephone number, extension for User?phones is properly configured

New Member

Re: Attendant consoel line status

Numbers are properly configured. I tried sniffing the traffic on the PC where AC is installed, and i get no UDP traffic. (as far as i know line status is transmitted via UDP)

Regards,

Marko

New Member

Re: Attendant consoel line status

The problem was with DNs being configured as full numbers (12345XXXX) in directory, so we had to use Application Dial Rules to discard the non-extension digits to make this work.

130
Views
0
Helpful
5
Replies