Currently I'm trying to install an attendant console and am having an issue when associating the Pilot Point to the Application user in Controlled devices.
When clicking on Find More Pilot Points, the pilot point in question is listed however when selecting 'add selected' it simply sits there and does nothing. I can add a physical extension to the controlled device field but not a pilot point!
On further investigation I've found the Pilot point is not registered and doesn't have an IP address, could this be causing the issue? If it is how do I get the pilot point registered?!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...