Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Australian Dial Plan on CCME

Hi,

Does anyone have the complete dial plan necessary to implement into a CCME for West Australia ?

best regards

Olivier

2 REPLIES
Hall of Fame Super Gold

Re: Australian Dial Plan on CCME

Hi, usually CCME doesn't require a very complete dialplan. I haven't checked Australia, but if numbers there are of fixed length, configure DP so that there is no T in destinaion-pattern, just as many dots as necessary. That is the first and most important improvement you can do.

Cisco Employee

Re: Australian Dial Plan on CCME

This tech note summarises the AU dial plan - you might need to change the local 8 digit numbering depending on the location of the gateway router -

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800945b9.shtml

Otherwise use a destination pattern of '0.T' :-)

161
Views
0
Helpful
2
Replies