Is there any way to set up Intercom so that it only works on internal extensions. Outside calls coming from the Auto Attendant should ring the line. I figure I may have to do it with two seperate lines, but was hoping I could use partitions or some other means.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.