Auto Answer speaker phone internal line, but not PSTN call?
Is there anyway to change the behavior of the auto answer configuration for each line? Clearly, it's either on or it's off. But the customer has an old key system that auto answers internal calls, but when external PSTN calls come in, the phone rings 4 times, then to VM. I have played around in MGCP with the ONNET OFFNET setting and that did not change anything.
Service Parameter? Or is this not possible in CUCM
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...