dial-peer voice 301 voip destination-pattern 191 session protocol sipv2 session target ipv4:126.96.36.199 dtmf-relay sip-notify codec g711ulaw no vad
When I am calling from my ip phone the 191 extension I can hear the "welcome to the automated attendant". Press 0 to call the operator number, or the extension. When I press an extension the phone rings. But what I want is when somebody calls our company to first hear the auto attendant. How can I configure the call manager to match the auto-attendant number with the called number?
Depending on which voice port the call will come in on and what the called number will be, change the corresponding translation rule. So, if the called number were 024009 coming in on port 0/2/0, you would add the following:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...