Auto select line 2 for outgoing calls 7941G CUCM 8.6

George Banuelos · ‎08-28-2013

Greetings,

Have a request for setting up Auto-select of line 2 on a 7941G for outbound calling when going off-hook. The 'Always Use Prime Line' option is set to off, but this setting is used to allow atuomatic line selection for inbound calling and not outbound. How can this be configured on CUCM 8.6?

Thank you,

George

"I believe that the greatest work of God has not been in the miraculous, nor in the spectacular, incomprehensible Creation, but rather I believe it was accomplished on the Cross where He Himself purchased the redemption of His Bride... the salvation of m

Rob Huffman · ‎08-29-2013

Hi George,

Although this feature is an option on some older PBX's like

the Nortel CS1000 it has never been available for CUCM

You could try opening PER to try and get this added in a future version.

Cheers!

Rob

"A smile relieves a heart that grieves"

- Stones

George Banuelos · ‎08-29-2013

sure, how can this PER be submitted?

"I believe that the greatest work of God has not been in the miraculous, nor in the spectacular, incomprehensible Creation, but rather I believe it was accomplished on the Cross where He Himself purchased the redemption of His Bride... the salvation of m

Rob Huffman · ‎08-30-2013

Hi George,

Only your Cisco account team (CAM & SE) can open a

PER (Product Enhancement Request) on your behalf. You

will need to work with them for this requst. I have seen this

requirement/need discussed here a few times so you're probably

not alone

Cheers!

Rob

"A smile relieves a heart that grieves"

- Stones

George Banuelos · ‎08-30-2013

Thank you for the follow up!

"I believe that the greatest work of God has not been in the miraculous, nor in the spectacular, incomprehensible Creation, but rather I believe it was accomplished on the Cross where He Himself purchased the redemption of His Bride... the salvation of m