Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AutoAttendant over E1

Hello everyone,

I have a CUCM 7.1 and a 2811 in the same site. The router has 4 FXO ports and 2 E1 ports.

I have configured an AA application (tcl script) on the router and it was working fine for incoming calls over the FXO ports.

The AA application would allow ether dial-by-extension or transfer to the operator.

However, when i added the E1 ports, although the AA would be triggered, i wouldn't be able to dial by extension or transfer to the operator.

I would get "All our agents are currently busy" message

The call flow would be come to the H323 gateway to the callmanager, where I have the translation patterns then it would go back to the H323 gateway to trigger the AA application. Could this flow be the problem?

Should I do the translation on the gateway itself then forward to the callmanager?

thanks,

Ahmed

1 REPLY
New Member

Re: AutoAttendant over E1

Could you pleas add show run for your router?

236
Views
0
Helpful
1
Replies