Re: Automatically adding a # when dialing a number using CME 4
The delay is normal when you use T in destinatio-pattern. You can set "timeouts interdigit" to 3. Also, if you know that certain numbers are of fixed length (eg, all number starting with 45.....) are 8 digits,configure them in destination-pattern and for these there will no delay.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.