Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AutoQOS with non Cisco VOIP solution

Hi All,

Can I deploy AutoQOS on my LAN switching and layer 3 switching when using a Siemens VOIP solution. I realise that their phones do not do CDP, so I need to trust the COS on the access port. But can I use all the other AutoQOS settings?

Thanks in advance for your feedback.

Scotty

3 REPLIES

Re: AutoQOS with non Cisco VOIP solution

thierically should be fine if you trust dscp or cos on the access ports and dscp on the uplinks trunks

but make sure from the marking is it cos 5 for voice for example and cos 3 signaling

if not u need to change you qos accordingly

try to capture you trafic with wireshark for example and see the marking

good luck

HTH

New Member

Re: AutoQOS with non Cisco VOIP solution

Thanks for the reply.

So what do I do if I want to add other QOS classificatios, like I want to set Citrix traffic into the interactive class. Do I just have to mark the traffic and that is all?

Cheers

Scotty

Re: AutoQOS with non Cisco VOIP solution

ok marking will be ok to mark the traffic but what after marking ?

you need to think do you need to have policies to prioritize some traffic over other

this way you can use the marked traffic and give to each class bandwidth acorrdengly

HTH

132
Views
0
Helpful
3
Replies
CreatePlease to create content