I am trying to implement Autoqos on router 2610XM and 1760.The interface is Frame-Relay Point to Point and bandwidth less than 768 kbps.IP CEF is also enable and the ios version is 12.4 IPvoice and Spservices. I tried various other platform like 2801,2811,2821 and IOS but was not able to implement "auto qos voip"command on the Fr subinterface nor on actual interface. I also tried the Fastethernet no support for the command .Not sure what is wrong the book does not mention anything about supported IOS or platform. Any help will be much appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...