Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

B-ACD doesn't work properly

Hi,

Two months ago I configure the b-acd of CME and works ok with 2.1.2.2 tcl. After, we made an update of the 2801 IOS to 12.4(9)T (CME 4.0)and doesn't work ok, I mean, the welcome message is played and the menu options too, but when you try option 1 (dial-by extesion) or option 2 (hunt group) it doesnn't notice and never acts. After, second greeting is played but never it receive the options dialed. I don't know where is the problem, the b-acd configuration commands are the same and I think the version of tcl is correct with that IOS.

I have changed some commands, change the name, folders of tcl and options, but the problem continues.

Thank you very much

Fernando

2 REPLIES
Silver

Re: B-ACD doesn't work properly

Could you please upload the configuration so that we could analyze things exactly.

Hall of Fame Super Gold

Re: B-ACD doesn't work properly

Hi,

which exact version of 12.4(9)T are you using? How are you connected to PSTN ?

Can you enable "debug vpm signal" and check if tones are detected ?

122
Views
0
Helpful
2
Replies
CreatePlease to create content