Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

B Channel Selection for 2 PRIs

Hello everyone,

On a setup that will use 2 PRIs with the hunt group set up to use both PRIs for access to all 46 channels is there any reason for setting 1 PRI B Channel selection for low to high and the other for high to low or does it make more sense to set them both to the same?

Thanks in advance. All replies rated

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: B Channel Selection for 2 PRIs

Hi Angel,

If these PRI's are being used for Incoming calls only (which it sounds like they are) then they can both be set the same. You usually use the "Top Down" and "Bottom Up" configs when these PRI's are being deployed for both Incoming and Outgoing calls to prevent collisions :)

Hope this helps!

Rob

1 REPLY
Hall of Fame Super Red

Re: B Channel Selection for 2 PRIs

Hi Angel,

If these PRI's are being used for Incoming calls only (which it sounds like they are) then they can both be set the same. You usually use the "Top Down" and "Bottom Up" configs when these PRI's are being deployed for both Incoming and Outgoing calls to prevent collisions :)

Hope this helps!

Rob

195
Views
0
Helpful
1
Replies
CreatePlease to create content