Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Anonymous
N/A

BACD on MGCP

Hi,

I have CUCM 6.0 running in the network, Cu has remote site where we required BACD should runn

I have 2811 router with 12.4 15T IOS

I need a running config of BACD script.

Consider my dial in number is 8 digit

Please post guys i need it urgently.

I have extension in my network starting with 701501 701502

Also just the info site has only BRI line

What i required is when smeone dial that number it should say thkyou for calling XXXX please dial the extension number you wish to reach 2

And when someone dial the extension number it should go to the extension.

my dial-peer configuration will be

dial-peer voice 1 voip

session-target ipv4:loopback ip address

destination-pattern XXXXXXXX

service aa

I need BACD running configuation

Regards

Arshad

2 REPLIES
New Member

Re: BACD on MGCP

I see no one answer your call. You still need assistance here? Let me know

VIP Super Bronze

Re: BACD on MGCP

Hi,

To run BACD you need tcl scripts and tcl scripts is not supported with MGCP, beacuse for this to fuction the gateway needs to local control of calls whic MGCP does not have

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
141
Views
0
Helpful
2
Replies
CreatePlease to create content