Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Backup session Target?

Is it possible to configure a backup session target on a CUBE? It doesn't look like it, so how do you configure a backup trunk for termination?

5 REPLIES
New Member

Backup session Target?

i guess I just do a new voice service and dial peer....

Cisco Employee

Backup session Target?

Correct, you'll want to create a duplicate dial-peer with the same exact destination-pattern but make sure you have preference 1 configured since the default is preference 0 (the highest).  You can then have a different session-target on the second dial-peer for backup.  Also make sure to setup a voice class h323 1 for h225 timeout tcp establish 3, assuming it's an H323 dial-peer.

Hall of Fame Super Silver

Backup session Target?

Great reply from Joe (+5), in addition instead of using redundant dial-peers you can create a static SRV record on the GW and have the dial-peer point to that srv record instead.

HTH,

Chris

Cisco Employee

Backup session Target?

Good alternate solution Chris +5.

New Member

Backup session Target?

thanks, i'll give these a try

400
Views
10
Helpful
5
Replies