i will install 2 routers in remote site(in centralized call processing)one will be backup for the other .
i need to make both work as srst(primary srst and secondary srst) and i don't know how this will be done by the configuration as in the call manager administration i can also assign one srst refrence for each phone and i don't know how to configure the call manager where the ip phones know that there as backup srst for them
You can only have one SRST reference. If you have more phones than one SRST router can support, you could create two device pools, each using a distinct SRST reference. I would probably group them by extensions, so that you can configure dial-peers between the SRST routers easily so the phones can call one another.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...