Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth Points - 7206VXR

Hello,

Hi there

I get the following message in the output of show version:

PCI bus mb0_mb1 (Slots 0, 1, 3 and 5) has an aggregate of 600 bandwidth points.

Total of 200 bandwidth points have been used on PCI bus mbo_mb1.

PA's (PA-IO-2FE = 400) has/have over subscribed 200 bandwidth points in single

port configuration on PCI bus mbo_mb1.

PCI bus mb2 (Slots 2, 4, 6) has an aggregate of 600 bandwidth points.

Total of 0 bandwidth points have been used on PCI bus mb2.

PA's ( ) has/have over subscribed 0 bandwidth points in single port configuratio

n on PCI bus mb2.

I have a 7206VXR Router

with Cisco IOS Version c7200-ik9s-mz.123-9e.bin.

The mb0_mb1 PCI bus should take a total of 600 bandwidth points. The I/O

Controller C7200-I/O-2FE/E uses 400 bandwidth points. There are no other

PAs or SAs in the other slots. So I don't understand why does this message appears?

Thanks in advance.

1 REPLY
Silver

Re: Bandwidth Points - 7206VXR

The output from "show version" does not take into account the actual port status, and only calculates based on the assumption if this is a supported configuration or not. This is given that we only use half the number of ports available.

160
Views
1
Helpful
1
Replies
CreatePlease to create content