Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Barge and Join Across Lines

There is a new Service Parameter in my 5.1(2) UCM called

Clusterwide Parameters (Feature - Join Across Lines And Single Button Barge Feature Set)

Enable Single Button Barge and Join Across Lines:

System wide configuration of Single-Button Barge, CBarge feature .

Maximum length: 20

: In order for the change to take effect on a cluster-wide basis, you must either restart all affected Call Managers, reset all affected Device Pools, or restart/reset all affected phones.

I can't find any documentation on it other than what is says here. Does anyone have any experience with this or have you tried it yet?

Thanks in advance

309
Views
0
Helpful
0
Replies