Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Basic Call Queue

I have a Hunt Pilot configured to Queue. I have selected a MOH Source and Announcement and for testing, set the maximum numbers of callers in queue to 1. The MOH Audio Source Config is below...

Stream # 2

MOH Audio Source File SampleAudioSource

Initial Announcement                     "TagOffice"
Initial Announcement Played        Only for Queued Calls
Periodic Announcement                "TagOffice"
Periodic Announcement Interval   30

 

When i test this i get the "TagOffice" announcement and then it immediately plays it again....after that the ExampleAudioSource music plays for 30 seconds and i get the announcement.

I'm trying to figure out how to get the Announcement to play once....music for 30 seconds...then the announcement again. Any suggestions?

1 REPLY

Hi.Remove initial

Hi.

Remove initial announcement (select "---Not Selected--")  leave only periodic announcement .and you should obtain what are you looking for.

 

 

HTH

 

 

Regards

 

Carlo

Please rate all helpful posts "The more you help the more you learn"
62
Views
0
Helpful
1
Replies
CreatePlease login to create content