I'm trying to get a single 7970G phone to register against a 2611XM running CME 4.3 as part of studying for my CCNA Voice. I've done lots of reading around and come up with the config attached, but the phone I've got just sits at the Upgrading screen when its plugged in. I think I'm missing something fairly important on my config. I'm not even sure if its getting an IP address from the DHCP server...
At the moment, the hardware is configured 2611XM-fa0/0->PSU Brick->Phone.
Please can someone take a look and point me in the right direction?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...