Basic question on FXS and FXO;is the instructor correct?
During my CVOICE recent training, my instructor stated:
"Think that the FXS is the port connected to the wall. FXO is the port connected to the phone".
Then later I thought more about it and I've seen topologies in which the FXS port (which I know is the port which provides the dial tone) is connected directly to a (analog) phone. Then the FXO port from a gateway/router is connected to a PBX.
Do you think the instructor's remarks on FXS and FXO make sense? Below are the definitions of FXS and FXO by cisco.com.
FXO?The Foreign Exchange Office interface allows a connection to be directed to the PSTN's central office. The FXO interface also allows a connection to be directed to a standard PBX interface or if the local telecommunications authority permits. The FXO interface can also be connected to analog PBX station lines. This interface is of value for Off-Premises eXtension (OPX) applications.
FXS?The Foreign Exchange Station interface allows connection for basic telephone equipment, and keysets, and supplies ring, voltage, and dial tone. The FXS interface can be connected to standard analog PBX central office/network trunk ports.
E&M?The recEive and transMit interface allows connection for PBX trunk lines (tie lines). E&M is a signaling technique for two-wire and four-wire telephone and trunk interfaces.
Re: Basic question on FXS and FXO;is the instructor correct?
Ditto on fxS=Station and fxO=Office but also from a tech prospective, FXO ports expect grounding to be provided and tone voltage to be provided from a POTS line. Whereas, FXS ports provide ground (If ground-start) and provide dial-tone voltage to anything connected to it that will complete a circuit between Tip and Ring wires.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.