I'm in the process of setting up voice qos on our core switch that handles are routing. It is a cisco WS-C4507R with System image file is "bootflash:cat4000-i9s-mz.122-25.EWA1.bin". All uplink and downlink interfaces are a Gigabit. Our 4 IDFs plug into this same switch.
I'm looking for a easiest basic configuration for handling voice traffic. Does any one have a configuration that they have used in the past and would be willing to share?
Hello....correct We have just one Data Vlan (192.168.14.0 /23) and two voice vlans10.14.50.0 /23 and 10.14.52.0 /23.
Both L3 interfaces for voice subnets are on the same 4507. We have a second campus a few miles from are main campus that has a 4507 as well. They are connected via fiber and are also connected via trunks ( not a routed link). Currently we do not route but, plan to in the near future thus the reason for the second voice vlan. I felt it would be an easier transition when we do convert that into a routed link.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.