BAT in Phones with All Details but not Activate the device
Does anyone know of a way to BAT in phones using the All Details option, but without it automatically activating the device on a CUCM 8.5 intallation? Currently we create the dummy MAC address in the file and prepend it with BAT instead of SEP for the device. This allows us to still be able to use TAPS with Auto Registered phones. The issue is that when we BAT in the phones they go in with the "Device is Active" already checked and use up a license. So before the phone TAP'ed we are using two licenses per device, one for the BAT file and one for the Auto Registered device. We are doing it this way because if we used the "Insert Phones Specific Detail" option we would have about 40 different templates, and the customer wants to simplify their rollout.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...