As you have discovered DN's in different Partitions cannot dial each other :( My suggestion would be to use a Multi-Line IP Phone like a 7941 and configure the Bat Line on Line 2 (with appropriate Line Text Label) configure a standard DN on Line 1 (for normal calling capabilities)
There really is no other workaround that I know of.
Hope this helps!
EDIT: Jaime, hope all is well! You have revealed my horrendous typing skills again ;-)
Cheers Rob, I was just trying to work out if there was some way to route them across partitions.. Yep thats the only other way i thought it could be done, shame i wanted to bring them into the main partition through the call centre.. o well :) thanks for the help.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...