Best way to CM 6.X Intercom and Auto-Answer combo config
I'm about to do an IPT cut-over onto a CM6.1 cluster. Their traditional PBX had a feature for inside callers to the CEO would automatically go off-hook and answer. (Outside callers would not make the CEO's phone auto-answer.) Likewise, if the CEO was on a call and an inside person called the CEO, it would whisper in the CEO's ear. The CEO only has one line appearence. Therefore, I am trying to do all this with one line. So it looks like CM 6.x Intercom feature will work, but I also want the same line to perform normal call-handling for outside callers. Anyone have any ideas on how to do this?
Re: Best way to CM 6.X Intercom and Auto-Answer combo config
Unfortunately Intercom lines, as per design, doesn't take into account if a user is busy or not since they were developed to be the fastest way to make two users speak to each other 'always'. If an intercom line would ring busy if the user is on another call it will not make any difference with a normal line, apart from having the 'auto answer' enabled.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...