BLF'S FOR THE SAME DN BUT DIFFERENT PARTITIONS - FAIL!
I'd suggest this is probably working as intended. You have the same DN in different partitions, and want the phone to be able to differentiate between these... but it can't, as they are the same number. The order of partitions in teh subscribe CSS will pick one of them.
It may be have been a better design to consider having a prefix for either public/private or both lines (e.g. public line = 1000, private = *1000 or 81000). With this setup you would have no trouble differentiating the lines (with this, or with CTI applications which have similar issues) and you could allow dialling between 'private' lines with 4-digits by having a translation pattern in the private CSSs to translate *XXXX or 8XXXX to XXXX.
I guess it all depends on why you have this public/private parallel universe setup.
Please rate helpful posts..
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...