Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Block incoming call

DOes any body nkow if is possible to Block a incomming call a internal number and allow just that number we want ?

4 REPLIES

Re: Block incoming call

Hi,

Sure you can block a specified incoming calls.

but you can do it only with h323,cme

you cann't do it with cucm unless you use h323 gateway with it.

You'll do it by rule reject /../ under voice translation-rule then apply to aprofile, then apply this profile to your pots dial-peer

wish this be helpful

Best Regards

Re: Block incoming call

A customer of mine had a problem with cold callers calling one of their staff on a direct number and trying to sell them kitchen equipment. This happened 4+ times a day so I was asked to try to block the caller.

As the customer used MGCP gateways the best way that I found to do this was to implement a translation pattern matching the incoming CLI and translating the call destination to the Unity pilot point.

Unity was configured to play a message telling the caller that cold calls were not welcome.

Hall of Fame Super Gold

Re: Block incoming call

How exactly you route by CLI in CM ? In the past it has been said that it's not possible.

New Member

Re: Block incoming call

Hi Jamesha.Its a good solution

Bu in my case I want to block all incaming call and allow just 5 or 6 that Ia want to call me

333
Views
8
Helpful
4
Replies