Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bogen Tam-B rings a few times before picking up

We implemented tam-b at many locations and there is one particular location that the tab-b picks up, but it doesn't pick up fast enough. Takes about 3-4 rings. Is there a way to make the ring pick up faster then that. I was told to increase the ring voltage.

This device is connected through an FXS interface. This is the same setup as other sites.

1 REPLY
Community Member

Re: Bogen Tam-B rings a few times before picking up

Check the position of Aux switch S3 on the top of the unit. S3 OFF increases the time before the TAM-B answers in "station" (FXS) mode.

139
Views
0
Helpful
1
Replies
CreatePlease to create content