Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BRI config with CME 4.3

Hi ,

i have configured FXO interface with CME for PSTN outbound and inbound calls.

How to configure BRI for outbound calls. can anyone provide me a sample config.

regards

1 REPLY
New Member

Re: BRI config with CME 4.3

Hi,

Please see some sample configs below:

interface BRI0/1/0

no ip address

isdn switch-type basic-net3

isdn not-end-to-end 56

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

dial-peer voice 1 pots

description ** BRI pots dial-peer **

translation-profile incoming INCOMING

preference 1

destination-pattern 9T

incoming called-number .

direct-inward-dial

port 0/1/0

!

Hope this will help.

Regards,

Chandrasen

628
Views
5
Helpful
1
Replies
CreatePlease to create content